Ignition Switch: Service and Repair
Ignition SwitchIgnition Switch:
Removal and Installation
1. Depower the supplemental restraint system (SRS). For additional information, refer to Air Bag Systems.
2. Remove the 4 bolts, release the fastener and position the instrument panel lower panel aside.
^ To install, tighten to 9 Nm (80 inch lbs.).
3. Disconnect the hood release cable and the data link connector (DLC) from the instrument panel lower panel and remove the panel. Loosen the hood release cable nut.
^ To install, tighten to 20 Nm (15 ft. lbs.).
4. Remove the steering column upper shroud. Using a suitable tool, release the 2 clips (one on each side).
5. If equipped, remove the audio control switch.
^ Using a suitable tool, release the locking tab.
^ Disconnect the electrical connector.
6. Remove the steering column lower shroud.
1 Release the steering column locking lever.
2 Remove the screws.
7. Disconnect the ignition switch and the LH multi-function switch electrical connectors.
8. Remove the ignition switch.
^ Release the clips.
9. To install, reverse the removal procedure.