Transaxle Case
Transaxle CaseSpecial Tool(s) (Part 1):
Special Tool(s) (Part 2):
Disassembly
1. Remove the halfshaft seals (LH shown).
2. Using the special tools, remove the differential case bearing cups (LH shown).
3. Using the special tools, remove the final drive input gear bearing cup.
4. Using the special tool, remove the transfer shaft gear bearing cups (LH shown).
5. NOTE: Note the location of the bleed hole in the funnel in relation to the bottom of the case.
NOTE: Inspect the bleed hole for foreign material.
NOTE: If flatness of funnel is compromised during bearing removal, replace the funnel.
Remove the funnel.
6. Rotate the transaxle 180 degrees.
7. Using the special tools, remove the final drive input gear bearing cup.
Assembly
1. NOTE: The converter housing side bearing cups for the transfer shaft bearing and differential case bearing will be installed during the assembly of the transaxle.
Using the special tools, install the final drive input gear bearing cup.
2. Rotate the transaxle 180 degrees.
3. NOTE: Note the location of the bleed hole.
NOTE: Inspect the bleed hole for foreign material.
Install the funnel.
4. Using the special tools, install the LH transfer shaft gear bearing cup.
5. Using the special tools, install the final drive input gear bearing cup (LH shown).
6. Using the special tools, install the LH differential case bearing cup.
7. Using the special tools, install the halfshaft seals (LH shown).