Headlamp: Service and Repair

Headlamp Assembly









Removal and Installation

1. Remove the radiator grille.

2. NOTE: There is a blind metal snap located on the lower outboard side of the headlamp assembly that is disengaged by pulling upwards on the headlamp assembly.

Remove the 3 bolts and the headlamp assembly.

- Disconnect the electrical connectors.

- To install, tighten to 4 Nm (35 lb-in).

3. To install, reverse the removal procedure.
- If necessary, adjust the headlamps. For additional information, refer to Headlamp Adjustment Adjustments.