Turbine Shaft Speed (TSS) Sensor

4F27E

Turbine Shaft Speed (TSS) Sensor





Turbine Shaft Speed (TSS) Sensor









Removal

1. Remove the battery tray.

2. Remove the Air Cleaner (ACL) assembly.

1. Disconnect the crankcase ventilation hose.

2. Disconnect the ACL outlet hose.

3. Remove the bolts and pull out the ACL resonator.





3. NOTE: The resonator is plugged into the bracket.

Remove the ACL intake hose with the resonator.





4. Disconnect the Turbine Shaft Speed (TSS) sensor electrical connector.





5. Remove the TSS sensor bolt and sensor.
- Check the TSS sensor bore.





6. Inspect the O-ring seal for nicks or cuts; install a new O-ring if necessary.





Installation

1. Apply a light coat of clean transmission fluid to the O-ring seal before installation.





2. NOTE: Apply thread sealer to the bolt.

Install the TSS sensor and bolt.

- Tighten to 10 Nm (89 lb-in).





3. Connect the TSS sensor electrical connector.





4. NOTE: The resonator is plugged into the bracket.

Install the ACL intake hose with the resonator.





5. Install the ACL assembly.

1. Connect the crankcase ventilation hose.

2. Connect the ACL outlet hose.

3. Position the ACL into the resonator and install the bolts.





6. Install the battery tray.