Flywheel

Flywheel





Removal

1. With vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting Service and Repair.

2. Remove the manual transaxle and clutch. For additional information, refer to Clutch Service and Repair and Manual Transaxle/Transmission - MTX75 Removal.

3. Install the Flywheel Holding Tool and remove the 6 bolts and the flywheel.





Installation

NOTE: Engine balancing is not required. Balance weights should not be installed on the new flywheel.

NOTE: Special bolts are used for installation. Do not use standard bolts.

1. Install the flywheel and the 6 bolts.

2. Install the Flywheel Holding Tool.





3. NOTE: Special bolts are used for installation. Do not use standard bolts.

Tighten the bolts in the sequence shown in 3 stages.

- Stage 1: Tighten to 50 Nm (37 lb-ft).

- Stage 2: Tighten to 80 Nm (50 lb-ft).

- Stage 3: Tighten to 112 Nm (83 lb-ft).





4. Install the clutch and manual transaxle. For additional information, refer to Clutch Service and Repair and Manual Transaxle/Transmission - MTX75 Installation.