Turbine Shaft Speed (TSS) Sensor

Turbine Shaft Speed (TSS) Sensor





Turbine Shaft Speed (TSS) Sensor









Removal

1. Remove the battery tray. For additional information, refer to Battery, Mounting and Cables Battery Tray.

2. Remove the Air Cleaner (ACL) assembly. For additional information, refer to Intake Air Distribution and Filtering Air Cleaner.

3. Disconnect the Turbine Shaft Speed (TSS) sensor electrical connector.





4. Remove the TSS sensor bolt and sensor.
- Check the TSS sensor bore.





5. Inspect the O-ring seal for nicks or cuts; install a new O-ring if necessary.





Installation

1. Apply a light coat of clean transmission fluid to the O-ring seal before installation.





2. NOTE: Apply thread sealer to the bolt.

Install the TSS sensor and bolt.

- Tighten to 10 Nm (89 lb-in).





3. Connect the TSS sensor electrical connector.





4. Install the ACL assembly. For additional information, refer to Intake Air Distribution and Filtering Air Cleaner.

5. Install the battery tray. For additional information, refer to Battery, Mounting and Cables Battery Tray.