Pinpoint Test E: DTC P2533:14

Body Control Module B (BCM-B)

Pinpoint Tests

Pinpoint Test E: DTC P2533:14

Refer to Wiring Diagram Set 11, Fuse and Relay Information for schematic and connector information. Diagrams By Number

Refer to Wiring Diagram Set 89, Interior Lamps for schematic and connector information. Diagrams By Number

Normal Operation
- DTC P2533:14 (Ignition Switch Run/Start Position Circuit: Circuit Short To Ground Or Open) - an on-demand DTC that sets when the BCM-B detects no voltage from the run/start circuit.

This pinpoint test is intended to diagnose the following:

- Fuse
- Wiring, terminals or connectors
- BCM-B
- SJB

PINPOINT TEST E: DTC P2533:14

-------------------------------------------------
E1 CHECK THE RUN/START CIRCUIT FOR VOLTAGE


- Ignition OFF.
- Disconnect: BCM-B C4368a .
- Ignition ON.
- Measure the voltage between the BCM-B C4368a-7, circuit CBP35 (YE/GY), harness side and ground.




- Is the voltage greater than 10 volts?

Yes
GO to E4.

No
VERIFY the SJB fuse 35 (10A) is OK. If OK, GO to E2. If not OK, REFER to the Wiring Diagrams to identify the possible causes of the circuit short. Diagrams By Number

-------------------------------------------------
E2 CHECK THE RUN/START CIRCUIT FOR AN OPEN


- Ignition OFF.
- Disconnect: SJB C2280d .
- Measure the resistance between the BCM-B C4368a-7, circuit CBP35 (YE/GY), harness side and the SJB C2280d-23, circuit CBP35 (YE/GY), harness side.




- Is the resistance less than 5 ohms?

Yes
GO to E3.

No
REPAIR circuit CBP35 (YE/GY) for an open. CLEAR the DTCs. REPEAT the self-test.

-------------------------------------------------
E3 CHECK FOR CORRECT BCM-B OPERATION


- Disconnect the BCM-B connectors.
- Check for:
- corrosion
- damaged pins
- pushed-out pins
- Connect the BCM-B connectors and make sure they seat correctly.
- Operate the system and verify the concern is still present.
- Is the concern still present?

Yes
INSTALL a new BCM-B. REFER to Body Control Module B (BCM-B) Body Control Module B (BCM-B). CLEAR the DTCs. REPEAT the self-test. TEST the system for normal operation.

No
The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. CLEAR the DTCs. REPEAT the self-test. TEST the system for normal operation.

-------------------------------------------------
E4 CHECK FOR CORRECT BCM-B OPERATION


- Disconnect the BCM-B connectors.
- Check for:
- corrosion
- damaged pins
- pushed-out pins
- Connect the BCM-B connectors and make sure they seat correctly.
- Operate the system and verify the concern is still present.
- Is the concern still present?

Yes
INSTALL a new BCM-B. REFER to Body Control Module B (BCM-B) Body Control Module B (BCM-B). CLEAR the DTCs. REPEAT the self-test. TEST the system for normal operation.

No
The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. CLEAR the DTCs. REPEAT the self-test. TEST the system for normal operation.

-------------------------------------------------