Pinpoint Test F: DTC U0140:87

Body Control Module B (BCM-B)

Pinpoint Tests

Pinpoint Test F: DTC U0140:87

Normal Operation
- DTC U0140:87 (Lost Communication With Body Control Module: Missing Message) - a continuous memory DTC set by the BCM-B if data messages received from the SJB over the the Medium Speed Controller Area Network (MS-CAN) are missing for 5 seconds or longer.

This pinpoint test is intended to diagnose the following:

- Communication network concern
- BCM-B
- SJB

PINPOINT TEST F: DTC U0140:87

-------------------------------------------------
F1 VERIFY CUSTOMER CONCERN


- Ignition ON.
- Verify that there is an observable symptom present.
- Is an observable symptom present?

Yes
GO to F2.

No
The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.

-------------------------------------------------
F2 CHECK THE COMMUNICATION NETWORK


- Ignition ON.
- Enter the following diagnostic mode on the scan tool: Network Test .
- Carry out the network test.
- Does the SJB pass the network test?

Yes
GO to F3.

No
REFER to Module Communications Network Testing and Inspection, The SJB Does Not Respond To The Scan Tool.

-------------------------------------------------
F3 RETRIEVE THE RECORDED DTCs FROM THE SELF-TEST


- Check for recorded BCM-B DTCs from the self-test.
- Is DTC U3003:62 recorded?

Yes
GO to Pinpoint Test I. Pinpoint Test I: DTC U3003:62

No
GO to F4.

-------------------------------------------------
F4 RECHECK THE BCM-B DTCs


NOTE: If new modules were installed prior to the DTC being set, the module configuration may be incorrectly set during Programmable Module Installation (PMI) or the PMI may not have been carried out.

- Clear the DTCs. Repeat the BCM-B self-test.
- Is DTC U0140:87 still present?

Yes
GO to F5.

No
The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.

-------------------------------------------------
F5 CHECK FOR DTC U0140:87 SET IN OTHER MODULES


- Clear all DTCs.
- Ignition OFF.
- Ignition ON.
- Wait 10 seconds.
- Enter the following diagnostic mode on the scan tool: Self-Test .
- Retrieve the continuous memory DTCs from all modules.
- Is DTC U0140:87 or DTC U0140 set in any other module?

Yes
INSTALL a new SJB. REFER to Smart Junction Box (SJB) Service and Repair. CLEAR the DTCs. REPEAT the BCM-B self-test.

No
INSTALL a new BCM-B. REFER to Body Control Module B (BCM-B) Body Control Module B (BCM-B). TEST the system for normal operation.

-------------------------------------------------