Seat Backrest - Rear, Coupe

Seat Backrest - Rear, Coupe

NOTE: RH shown, LH similar.











Disassembly

1. Remove the rear seat backrest. For additional information, refer to Seat Backrest - Rear Rear Seat.

2. NOTICE: Use care when separating the backrest cover from the hook-and-loop strip. The hook-and-loop strip can be torn from the seat backrest foam.

Invert the backrest cover up the backrest to the head restraint.

1. Detach the backrest cover hook-and-loop strip at the lower outboard side.

2. At the bottom of the backrest cover, disengage the J-clips.

3. Detach the hook-and-loop strips and separate the backrest cover from the backrest foam pad.

4. Invert the backrest cover up the backrest to the head restraint.

3. Remove the head restraint assemblies.
- Push the buttons in at the top of the head restraint guide sleeves.

4. Remove the backrest cover.

5. Remove the backrest foam pad.

6. NOTE: Typical backrest frame shown.

Push the tab in on each head restraint guide sleeve to disengage the retainer, pull up and remove.





7. To assemble, reverse the disassembly procedure.