Wheel Speed Sensor - Front

Wheel Speed Sensor - Front









Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting Service and Repair.

2. NOTE: If the wheel speed sensor is disconnected with the ignition in the ACC or RUN position, a DTC will be set in the ABS module.

Turn the ignition to the OFF position.

3. Disconnect the wheel speed sensor electrical connector.

4. Disconnect the 3 wheel speed sensor harness pin-type retainers.

5. Disconnect the 2 wheel speed sensor grommets from the brake hose clips.

6. Remove the wheel speed sensor bolt.
- To install, tighten to 15 Nm (133 lb-in).

7. Remove the wheel speed sensor and harness assembly.

8. To install, reverse the removal procedure.