Camshaft Position Sensor: Service and Repair

Distributor Assembly:

DISASSEMBLY

1. Rotor from distributor housing.

2. Ignition coil dust cover and gasket from distributor housing.

3. Two nuts and four wires from the ignition coil terminals.

4. Four screws and ignition coil from distributor housing.

5. Three screws and three wires from the igniter terminals.

6. Two screws and igniter from distributor housing.

Distributor Connectors:

7. Two connectors from the harness retainer.

Distributor Harness Retainer:

8. One screw and harness retainer from distributer housing.

9. Distributor wire from distributor housing.

10. One screw and noise suppressor condenser from distributor housing.

Inspect

Inspecting The Distributor Shaft:

1. Shaft for roughness or wear. If it feels rough or worn, replace the distributor housing assembly.

2. Distributor cap and rotor for cracks, terminal corrosion and wear; replace as necessary.

REASSEMBLY

Install or Connect

1. Noise suppressor condenser to distributor housing; secure with one screw.

2. Distributor wire to distributor housing.

3. Harness retainer to distributor housing; secure with one screw.

4. Two connectors to harness retainer.

5. Igniter to distributor housing; secure with two screws.

6. Three wires to igniter terminals; secure with three screws.

7. Ignition coil to distributor housing; secure with four screws.

8. Four wires to ignition coil terminals; secure with two nuts.

NOTICE: When connecting the wires to the ignition coil, insert them properly into their grooves found on the side of the ignition coil and make sure the wires do not come in contact with the signal rotor or distributor housing.

Tighten

^ Ignition coil terminal nuts to 8 Nm (71 lb.in.).

9. Ignition coil dust cover and new gasket to distributor housing.

10. Rotor to distributor housing.