Ignition Control Module: Service and Repair

Igniter Terminal Screws:

Removing Igniter:

IGNITER REPLACEMENT


REMOVE OR DISCONNECT
1. Distributor from vehicle. Refer to Distributor Replacement. Service and Repair
2. Rotor from distributor housing.
3. Ignition coil dust cover and gasket from distributor housing.
4. Three screws and three wires from the igniter terminals.
5. Two screws and igniter from distributor housing.

INSTALL OR CONNECT
1. Igniter to distributor housing; secure with two screws.
2. Three wires to igniter terminals; secure with three screws.
3. Ignition coil dust cover and new gasket to distributor housing.
4. Rotor to distributor housing.
5. Distributor to vehicle. Refer to Distributor Replacement.