Engine Control Module: Service and Repair

ECM Location:

Carpet Retaining Bracket And ECM Mounting Brackets:

Installing ECM:

ENGINE CONTROL MODULE REPLACEMENT
The ECM is serviceable only as an assembly.

REMOVE OR DISCONNECT
1. Negative (-) battery cable.
2. Carpet retainer from carpet retaining bracket and pull back carpet from floor under glove box.
3. Two bolts and ECM with carpet retainer bracket from mounting bracket.
4. Three electrical connectors from ECM and ECM from vehicle.
5. One screw and carpet retaining bracket from ECM.
6. Four screws and ECM mounting brackets from ECM.
7. Plastic cover from top of ECM.

INSTALL OR CONNECT
1. Plastic cover to top of ECM.
2. Both ECM brackets to ECM; secure with four screws.
3. Carpet retaining bracket to ECM; secure with one screw.
4. Three electrical connectors to ECM and position ECM into mounting bracket, making sure that bracket slides into slot.
5. ECM with carpet retainer to mounting bracket; secure with two bolts. Tighten ECM mounting bolts to 15 Nm (11 lb. ft.).
6. Carpet to carpet retaining bracket by inserting carpet retainer into bracket.
7. Negative (-) battery cable. Tighten negative (-) battery cable-to-negative (-) battery terminal retainer to 15 Nm (11 lb. ft.).