Engine Control Module: Service and Repair

PCM Location:

Carpet Retaining And PCM Mounting Brackets:

Installing PCM:

POWERTRAIN CONTROL MODULE REPLACEMENT
The PCM is serviceable only as an assembly.

REMOVE OR DISCONNECT
1. Negative (-) battery cable.
2. Carpet retainer from carpet retaining bracket and pull back carpet from floor under glove box.
3. Two bolts and PCM with carpet retainer bracket from mounting bracket.
4. Three electrical connectors from PCM and PCM from vehicle.
5. One screw and carpet retaining bracket from PCM.
6. Four screws and PCM mounting brackets from PCM.
7. Plastic cover from top of PCM.

INSTALL OR CONNECT
1. Plastic cover to top of PCM.
2. Both PCM brackets to PCM; secure with four screws.
3. Carpet retaining bracket to PCM; secure with one screw.
4. Three electrical connectors to PCM and position PCM into mounting bracket, making sure that bracket slides into slot.
5. PCM with carpet retainer to mounting bracket; secure with two bolts. Tighten PCM mounting bolts to 15 Nm (11 lb. ft.).
6. Carpet to carpet retaining bracket by inserting carpet retainer into bracket.
7. Negative (-) battery cable. Tighten negative (-) battery cable-to-negative (-) battery terminal retainer to 15 Nm (11 lb. ft.).