Rear Disc Brake ServiceSteps

PROCEDURES
1. Check for applicable Technical Service Bulletins (TSB).
2. Perform Initial Test Drive and Diagnosis By Symptom.
Testing and Inspection
3. Begin repairs, lift and support rear of vehicle, remove rear wheels.
4. Remove caliper assembly.
Service and Repair
5. Inspect brake linings and caliper assembly.
Testing and Inspection
6. Rebuild or replace caliper assembly if necessary.
Service and Repair
7. Inspect brake rotor/hub assembly, replace or resurface if necessary.
Testing and Inspection
8. Remove and Install brake rotor/hub assembly.

9. Install new brake-pads and caliper assembly.
- Install new pads.
Service and Repair
- Install caliper assembly.
Service and Repair
10. Perform Brake Bleeding procedure.
11. Install tire and wheel assembly.
12. Perform After Repairs Test Drive.
Testing and Inspection

ENVIRONMENTAL AND SAFETY CONCERNS
Technician Safety Information