Tools - Engine Stand and Adapter Information

Bulletin No.
86-027

Issue Date
DEC 21, 1990

Model
ALL

Applicable To
ALL

File Under
SPECIAL TOOLS

Engine Stand and Adapter Information (Supersedes 86-027, dated October 31, 1986)

Engine stands and adapters are no longer supplied by American Honda. The following information about equivalent equipment is provided for your reference. There may be other commercially available equipment which also meets special tool requirements (section 3.0 of the Automobile Dealer Sales and Service Agreement).

Engine Stand
If you need additional engine stands, this Kent-Moore unit will accommodate all Honda four-cylinder engines. The bolts and washers you'll need to mount an engine to this stand are listed under Ordering Information below.

Engine Stand Adapter The Kent-Moore (maximum load capacity 300 pounds) will enable your existing Honda Engine Stand to accommodate all Honda four-cylinder engines. The bolts and washers you'll need to mount an engine to this adapter are listed under Ordering Information below.

Ordering Information
You'll need the following bolts and washers to mount an engine to the stand or the adapter shown above. You can order them from American Honda. Order the engine stand and engine stand adapter from Kent-Moore at the address/phone number below.

Bolt 10 x 130 mm (Quantity 3)
H/C 0624981, P/N 95700-10130-08

Bolt 10 x 160 mm (Quantity 1)
H/C 1364090, P/N 95700-10160-08

Bolt 12 x 125 mm (Quantity 3)
H/C 0450023, P/N 92130-12125-0A
Used with three 12 mm washers.

Washer 10 mm (Quantity 4)
H/C 2128536, P/N 90504-SE0-000

Kent-Moore Tool Group
SPX Corporation
28635 Mound Road
Warren, MI 48092

Attn: Order Desk
(800) 345-2233

Engine Stand Transmission Adapter
This Owatonna Engine Stand Transmission Adapter will bolt to the Kent-Moore Engine Stand and Engine Stand Adapter as shown.

Ordering Information
OTC(R)
Owantonna Tool Company
SPX Corporation
655 Eisenhower Drive
Owatonna, MN 55060

Attn: Honda Order Desk
(800) 533-5338