Disconnecting/Connecting Connectors
Installing the short connectorWARNING: TO AVOID ACCIDENTAL DEPLOYMENT AND POSSIBLE INJURY, ALWAYS INSTALL THE PROTECTIVE SHORT CONNECTOR(S) ON THE DRIVER'S AND PASSENGER'S AIRBAG CONNECTOR(S) BEFORE WORKING NEAR ANY SRS WIRING.
NOTE: The radio may have a 5-digit coded theft protection circuit. Be sure to get the customer's code number before disconnecting the battery.
1. Disconnect the battery negative cable, then disconnect the positive cable.
2. Install the short connector(s)(RED):
Driver's Side:
- Remove the access panel from the steering wheel, then remove the short connector (RED) from the panel.
Drivers Side Short Connector Installation:
- Disconnect the 3-P connector between the driver's airbag and cable reel, then install the short connector (RED) on the airbag side of the connector.
Front Passenger's Side:
- Remove the glove box, then remove the short connector (RED) from itS holder.
- Disconnect the 3-P connector between the front passenger's airbag and SRS main harness, then install the short connector (RED) on the airbag side of the connector.
Disconnecting the SRS Connector at the Fuse Box
CAUTION: Avoid breaking the connector; it's doublelocked.
1. First lift the connector lid with a thin screwdriver, then press the connector tab down and pull the connector out.
Fig. 14 Fuse Panel/SRS Connector:
2. To reinstall the connector, push it into position until it clicks, then close its lid.