Without Scan Tool

EXTRACT THE FAULT CODES AS FOLLOWS

Data Link Connector and SCS Connector (with Shorting Service Connector installed):

1. Connect the Service Check Connector terminals together with either a jumper wire or the Honda Service Check Connector (P/N 07PAZ-0010100). The Service Check Connector is located under the glovebox hinge and is a blue 2 pin female connector.

NOTE: Do not short the terminals of the 3 pin Data Link Connector (DLC) together. Damage to the Engine Control Module (ECM) may result.

Malfunction Indicator Lamp:

2. The Check Engine light on the instrument panel indicates a failure code by blinking frequency. The Check Engine light can indicate any number of simultaneous component problems by blinking separate codes, one after another. Problem codes 1 through 9 are indicated by individual short blinks. Problem codes 10 through 43 are indicated by a series of long and short blinks. The number of long blinks equals the first digit, the number of short blinks equals the second digit. Add the long and short blinks together to determine the fault code.