Clearance Inspection

1. Measure the clearances between the reverse change holder and the 5th/reverse shift piece pin.




2. If the clearance are not within the standard, measure the width of the grooves in the reverse change holder.
- If the width of the grooves are not within the standard, replace the reverse change holder with a new one.
- If the width of the grooves are within the standard, replace the 5th/reverse shift piece with a new one.




3. Measure the clearance between the reverse idler gear and the reverse change holder.




4. If the clearance is more than the service limit, measure the width of the reverse change holder.
- If the width is not within the standard, replace the reverse change holder with a new one.
- If the width is within the standard, replace the reverse idler gear with a new one.