Gauge Assembly Removal

Gauge Assembly Replacement:

CAUTION:
^ All SRS wire harnesses are covered with yellow insulation. Before you disconnect any part of an SRS wire harness, disconnect the airbag connectors.
^ Whenever the ignition switch is ON (II), or has been turned OFF for less than three minutes, be careful not to bump the SRS unit; the airbags could accidentally deploy and cause damage or injuries.
^ For additional precautions, refer to Air Bags and Seat Belts.

Gauge Assembly Replacement:

1. Remove the two screws.

Gauge Assembly Replacement:

2. Disconnect the connectors, then remove the instrument panel.

Gauge Assembly Replacement:

3. Remove the three screws.

Gauge Assembly Replacement:

4. Pull out the gauge assembly, and disconnect the connectors, then remove the gauge assembly.
5. Install the gauge assembly in the reverse order of removal, then check the operation of all lights and gauges.