Driven Pulley Shaft Bearing Replacement

TOOL REQUIRED
- 07749-0010000 Driver
- 07746-0010600 Attachment, 72 x 75 mm
- Or Equivalent





1. To remove the driven pulley shaft bearing from the transmission housing, expand the snap ring with snap ring pliers, then push the bearing out using the special tools and a press as shown.

NOTE: Do not remove the snap ring unless it's necessary to clean the groove in the housing.

2. Expand the snap ring with snap ring pliers, insert the new bearing part-way into the housing using the special tools and a press as shown. Install the bearing with the groove facing outside the housing.

NOTE: Coat all parts with CVT Fluid.





3. Release the pliers, then push the bearing down into the housing until the ring snaps in place around it, using the special tools as shown.





4. After installing the bearing verify the following:
- The snap ring is seated in the bearing and housing grooves.
- The snap ring operates properly.
- The ring end gap is correct.