Pressure Testing
TESTINGWARNING:
- While testing, be careful of the rotating front wheels.
- Make sure lifts, jacks, and safety stands are placed properly.
CAUTION:
- Before testing, be sure the transmission is filled to the proper level.
- Warm up the engine before testing.
1. Raise the front of the vehicle, and support it with safety stands.
2. Set the parking brake, and block rear wheels securely.
3. Allow the front wheels to rotate freely.
4. Warm up the engine (the radiator fan comes on), then turn off the engine and connect a tachometer.
5. Connect the special tool to the line pressure and clutch pressure inspection holes.
TORQUE: 18 Nm (13 ft. lbs.)
6. Start the engine, and run it at 2,000 rpm.
7. Shift to [N] or [P] position, and measure line pressure.
NOTE: Higher pressure may be indicated if measurements are made in shift lever positions other than [N] or [P] position.
8. Shift to the respective shift lever position, and measure clutch pressure as shown.
9. Install the sealing bolts with new sealing washers, and tighten the bolts to the specified torque.
TORQUE: 18 Nm (13 ft. lbs.)
NOTE: Do not reuse old sealing washers.