Steering Column: Service and Repair

Removal and Installation
SRS components are located in this area. Review the SRS component locations, precautions, and procedures in Restraint System before performing repairs or service.

Removal
1. Record the radio station presets, and disconnect the battery.
2. Remove the driver's airbag, steering wheel, and cable reel.
3. Remove the column covers (A).
4. Remove the combination switch assembly (B) from the steering column shaft by disconnecting the connectors and removing the screws.
5. Disconnect the ignition switch connectors from the under-dash fuse/relay box.
6. Remove the steering joint bolt (C).
7. Remove the steering column (D) by removing the attaching nuts (E) and bolts (F).

Installation
1. Install the steering column, and make sure the wires are not caught or pinched by any parts.





2. Insert the lower end of the steering joint (A) onto the steering shaft (B) (line up the bolt hole (C) with the flat portion (D) on the shaft).
3. Pull on the steering joint to make sure that the steering joint is fully seated, but do not pull excessively on the joint. Then install the steering joint bolt (E) and tighten it to the specified torque.
US thru VIN JHMAP 114-YT008411
Canada thru VIN JHMAP 114-YT800750
Torque: 22 Nm (2.2 kgf-cm, 16 ft. lbs.)
US from VIN JHMAP 114-YT008412
Canada from VIN JHMAP 114-YT800751
Torque: 29 Nm (3.0 kgf-cm, 22 ft. lbs.)
4. Finish the installation, and note these items:
- Make sure the wire harness is routed and fastened properly. Make sure the connectors are properly connected.
- Reinstall the steering wheel.
- Reconnect the battery and reset the radio presets.
- Verify cruise control, horn, and turn signal switch operation.
- Check wheel alignment.