Keyless Entry Module: Testing and Inspection
Control Unit Input Test1. Before testing, troubleshoot the multiplex control system.
2. Remove the driver's dashboard lower cover.
Keyless/Power Door Lock System - Control Unit Input System:
3. Disconnect the under-dash fuse/relay box connectors.
NOTE: All connectors are wire side of female terminals,
4. Inspect the connector and socket terminals to be sure they are all making good contact.
- If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
- If the terminals look OK, go to step 5.
5. Reconnect all connections to the under-dash fuse/relay box, turn the ignition switch ON (II) to wake-up the system, and make these input tests at the appropriate connectors on the under-dash fuse/relay box.
- If any test indicates a problem, find and correct the cause, then recheck the system.
- If all the input tests prove OK, go to step 6.
6. Disconnect the M, P, K and J connectors from the under-dash fuse/relay box, and make these input tests at the connectors.
- If any test indicates a problem, find and correct the cause, then recheck the system.
- If all the input tests prove OK, the multiplex control unit must be faulty, replace the under-dash fuse/relay box assembly.