P0506

DTC P0506: Idle Control System RPM Lower Than Expected

NOTE:
- If DTC P0511 is stored at same time as DTC P0506, troubleshooting DTC P0511 first, then recheck for DTC P0506.
- Information marked with an asterisk (") applies to Canada model.

1. Start the engine. Hold the engine speed at 3,000 rpm with no load (in Park or neutral) until the radiator fan comes on, then let it idle.
2. Check the engine speed at idle under no-load conditions: headlights, blower fan, rear defogger, and air conditioner off.

Is the engine running at 700 ± 50 rpm (720 ± 50 rpm)*?

YES - Intermittent failure, system is OK at this time.

NO - Go to step 3.

3. Turn the ignition switch OFF.
4. Disconnect the IAC valve 3P connector.
5. Start the engine, and let it idle.
6. Check the engine speed at idle with no-load conditions: headlights, blower fan, rear defogger, and air conditioner off.

Does the engine speed increase or fluctuate ?

YES - Check the idle speed under a different load conditions (electrical, A/C, gear position, P/S, etc.). If it's out of specification, replace the IAC valve.

NO - Replace the IAC valve.