Equipment Service and Warranty

To service the MATRIX H Key Cutting Machine, refer to section 7 of the MATRIX H Operating Manual. It tells you how to replace parts that commonly wear out such as the drive belt, the work light bulb, and the tension spring on the vertical carriage. It also covers checking and replacing fuses and replacing the printed circuit board for the setting unit keypad.

If you have technical questions on the equipment, contact the Ilco Technical Assistance Department.

Mail:
Kaba Ilco Technical Assistance Department
400 Jeffreys Road
Rocky Mount, NC 27804

Phone: 800-452-6872 Ext: 200, 384, 323, 398, 356
Fax: 252-446-4702

The MATRIX H Key Cutting Machine comes with a 3-year limited warranty. This warranty does not cover the cutter bit or the work light bulb.

CODE BOOK CORRECTIONS

In the code book Honda High Security key Codes, correct these errors:

Pages 4 thru 51, code headings:

^ Incorrect: J H G F Z X E D C B M/S X

^ Correct: J H G F A X E D C B M/S X

Page 2, last paragraph:

^ Incorrect: "If a Master Key is to be cut, put a five (5) in the blank space. Use a two (2) if a valet key is needed."

^ Correct: "If a Master Key is to be cut, put an M in the blank space. Use an S if a valet key is needed."

Page 2, legend at the bottom:

^ Incorrect: "C. If a Master key is desired, then the number five (5) should be placed in the M/S position. Place the number two (2) in the M/S column if a Sub (Valet) key is needed."

^ Correct: "C. If a Master Key is desired, then an M should be placed in the M/S position. Place an S in the MIS column if a Sub (Valet) key is needed."