Under-Dash Fuse/Relay Box

Removal and Installation

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before performing repairs or service.

Removal

1. Make sure you have the antitheft codes for the radio and the navigation system, then write down the customer's audio station presets and XM radio channel presets. Make sure the ignition switch is OFF.
2. Connect the HDS to the data link connector (DLC), and ground the SCS.
3. Disconnect the battery negative cable, then disconnect the positive cable, and wait at least 3 minutes.
4. Remove the left front door Sill trim and left kick panel.




5. Disconnect the connectors from the fuse side of the under-dash fuse/relay box (A).
6. Remove the two mounting bolts and pull the fusel relay box away from the body.
7. Disconnect the connectors and remove the under-dash fuse/relay box.

NOTE: Some SRS harness connectors are spring-loaded lock type.

8. Carefully remove the relays. Do not use pliers.

Installation:

1. Install the removed relays.
2. Connect connectors to the under-dash fusel relay box, then install the under-dash fuse/relay box in the reverse order of removal.
3. Install the removed parts in the reverse order of removal.
4. Connect both the positive cable and negative cable to the battery.
5. Reset the power window control unit.
6. Enter the anti-theft codes for the radio and navigation system, then enter the customer's audio station presents and XM radio channel presets.
7. Confirm that all systems work properly.