B1010

DTC B1010: MICU Lost Communication with Door Multiplex Control Unit (Panic Message)

1. Clear the DTCs using the HDS.
2. Cycle the ignition switch to OFF and then back ON.
3. Check for DTCs using the HDS.

Is DTC B1010 indicated?

YES - Go to step 4.

NO - Intermittent failure, the door multiplex control unit is OK at this time. Check for loose or poor connections. If the connections are good, check the battery condition and the charging system.

4. Check for DTCs of the relay control module using the HDS.

Is DTC B1059 indicated?

YES - Go to the Door Multiplex Control Unit Input Test. Door Multiplex Control Unit Input Test

NO - Check for an open in the communication circuit between the MICU and the door multiplex control unit. If the circuit is OK, replace the MICU. If the circuit is bad, repair the open.