IMA System

DTC P0A5E (24): U Phase Motor Current Sensor Circuit Low Voltage

NOTE: Before you troubleshoot, record all freeze data, and review the general troubleshooting information.

1. Turn the ignition switch ON (II).
2. Check the U PHASE MOTOR CURRENT SENSOR in the DATA LIST with the HDS.

Is about 0.25 V or less Indicated?

YES - Go to step 3.

NO - Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the MCM.

3. Update the MCM if it does not have the latest software, or substitute a known-good MCM.
4. Turn the ignition switch ON (II).
5. Check for Temporary DTCs or DTCs with the HDS.

Is DTC P0A5E (24) indicated?

YES - Check for poor connections or loose terminals at the MCM. If the MCM was updated, substitute a known-good MCM, then go to step 4. If the MCM was substituted, go to step 1.

NO - Go to step 6.

6. Monitor the OBD STATUS for P0A5E (24) in the DTCs MENU with the HDS.

Does the screen indicate PASSED?

YES - If the MCM was updated, troubleshooting is complete. If the MCM was substituted, replace the original MCM. If any other Temporary DTCs or DTCs were indicated in step 5, go to the indicated DTCs troubleshooting.

NO - If the screen indicates FAILED, check for poor connections or loose terminals at the MCM; If the MCM was updated, substitute a known-good MCM, then go to step 4. If the MCM was substituted, go to step 1. If the screen indicates NOT COMPLETED, keep the ignition switch ON (II) until a result comes on.