DTC Troubleshooting

DTC P2279: Intake Air System Leak Detected

NOTE:
- Before you troubleshoot, record all freeze data and any on- board snapshot, and review the general troubleshooting information.
- If DTC P0443 is stored at the same time as DTC P2279, troubleshoot DTC P0443 first, then recheck for DTC P2279.

1. Check for vacuum leaks at these parts:
- PCV valve
- PCV hose
- EVAP canister purge line
- Throttle body
- Intake manifold
- Brake booster and hose

Are the parts OK?

YES - Go to step 2.

NO - Repair or replace the leaking part(s), then go to step 4.

2. Start the engine. Hold the engine speed at 3,000 rpm without load (in Park or neutral) until the radiator fan comes on, then let it idle for 1 minute.
3. Monitor the OBD STATUS for DTC P2279 in the DTCs MENU with the HDS.

Does the screen indicate FAILED?

YES - Check the camshaft timing, then go to step 4.

NO - If the screen indicates PASSED, intermittent failure, system is OK at this time. If the screen indicates NOT COMPLETED, go to step 2 and recheck.

4. Reset the ECM/PCM with the HDS.
5. Do the ECM/PCM idle learn procedure.
6. Check for Temporary DTCs or DTCs with the HDS.

Is DTC P2279 indicated?

YES - Check for vacuum leaks at the PCV valve, the PCV hose, the EVAP canister purge line, the throttle body, the intake manifold, or the brake booster and hose, then go to step 4.

NO - If Temporary DTC or DTC P2279 is not indicated, or if any other Temporary DTCs or DTCs are indicated, go to step 7.

7. Monitor the OBD STATUS for DTC P2279 in the DTCs MENU with the HDS.

Does the screen indicate PASSED?

YES - If there was no Temporary DTCs or DTCs indicated on step 6, troubleshooting is complete. If any other Temporary DTCs or DTCs was indicated on step 6, go to the indicated DTC's troubleshooting.

NO - If the screen indicates FAILED, go to step 1 and recheck. If the screen indicates NOT COMPLETED, go to step 5 and recheck.