Repair Procedure B

*NOTE:
This procedure only applies to used vehicles.

Before doing this procedure, make sure you were directed here by the inspection procedure. If not, go to INSPECTION PROCEDURE, and follow the steps.

1. Remove the following parts. Refer to the service manual as needed.

^ Right front door seal (as needed)

^ Right kick panel

^ Right front sill trim

^ Both rear door seals (as needed)

^ Both rear door sill trim

^ Rear trim panel

^ Cargo area floor

^ Both cargo area side trim panels

^ Both quarter pillar trim

^ Both front seats

^ Center console

^ Rear heater upper duct

^ Both lower B-pillar trim

^ Both seat belt tensioners

^ Both front door switches

^ Carpet (as needed)











2. Replace the floor wire harness.

NOTE:
You will need to raise the vehicle on the lift and remove the EVAP canister to access the connector at the EVAP cannister subharness.

3. Reinstall all removed parts.

4. Reconnect the negative cable to the battery.

5. Enter the audio presets, and set the clock.

6. Turn the ignition switch to ON (II), and make sure the SRS indicator comes on and then goes off.

7. Do the idle learn procedure:

^ Make sure all electrical items (A/C, audio unit, defogger, lights, etc.) are off.

^ Start the engine, and let it warm up to its normal operating temperature (the cooling fans cycle twice).

^ Let the engine idle (throttle closed and all electrical items off) for 10 minutes.

8. Test-drive the vehicle, and make sure everything works properly. Also, make sure there are no rattles.





9. Center-punch a completion mark above the third character of the engine compartment VIN.

10. If not already completed, do Service Bulletin 07-011, Safety Improvement Campaign: Fit SRS Unit Reprogramming.*