DTC Troubleshooting
DTC P0761: Shift Solenoid Valve C Stuck OFFDTC P0762: Shift Solenoid Valve C Stuck ON
NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review General Troubleshooting Information.
1. Warm up the engine to normal operating temperature (the radiator fan comes on).
2. Make sure that the transmission is filled to the proper level, and check for fluid leaks.
3. Drain the ATF through a strainer. Inspect the strainer for metal debris or excessive clutch material.
Does the strainer have metal debris or excessive clutch material?
YES - Replace the transmission, then go to step 14.
NO - Replace the ATF, then go to step 4.
4. Clear the DTC with the HDS.
5. Test-drive the vehicle in D through all five gears, then slow down to a stop.
6. Turn the ignition switch to LOCK (0), and repeat the test-drive in step 5.
7. Monitor the OBD status for P0761 or P0762 in the DTCs/Freeze Data in A/T Mode Menu for a pass/fail.
Does the HDS indicate FAILED?
YES - Go to step 8.
NO - Intermittent failure, the system is OK at this time. If the HDS indicates NOT COMPLETED, return to step 5 and recheck.
8. Clear the DTC with the HDS.
9. Select Shift Solenoid C in the Miscellaneous Test Menu, and check that shift solenoid valve C operates with the HDS.
Is a clicking sound heard?
YES - Go to step 10.
NO - Replace shift solenoid valve C, then go to step 13.
10. Test-drive the vehicle in D through all five gears, then slow down to a stop.
11. Turn the ignition switch to LOCK (0), and repeat the test-drive in step 10.
12. Monitor the OBD status for P0761 or P0762 in the DTCs/Freeze Data in A/T Mode Menu for a pass/fail.
Does the HDS indicate FAILED?
YES - Repair shift valve C, or replace the transmission, then go to step 13.
NO - Intermittent failure, the system is OK at this time. If the HDS indicates NOT COMPLETED, return to step 10 and recheck.
13. Clear the DTC with the HDS.
14. Test-drive the vehicle in D through all five gears, then slow down to a stop.
15. Turn the ignition switch to LOCK (0), and repeat the test-drive in step 14.
16. Monitor the OBD status for P0761 or P0762 in the DTCs/Freeze Data in A/T Mode Menu for a pass/fail.
Does the HDS indicate PASSED?
YES - Troubleshooting is complete.
NO - Return to step 13 and recheck. If the HDS indicates NOT COMPLETED, return to step 14 and recheck.