DTC Troubleshooting

DTC Troubleshooting: P0603, P062F (PGM-FI System)

DTC P0603: ECM/PCM Internal Control Module Keep Alive Memory (KAM) Error ('06-08 models)

DTC P062F: ECM/PCM Internal Control Module Keep Alive Memory (KAM) Error ('09 model)

NOTE:

- Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. Initial Inspection and Diagnostic Overview

- Information marked with an asterisk (*) applies to the '06-08 models.

- Information marked with a double asterisk (**) applies to the '09 model.

1. Turn the ignition switch to ON (II).

2. Clear the DTC with the HDS.

3. Check for Temporary DTCs or DTCs with the HDS.

Is DTC P0603* (P062F)** indicated?
YES - Go to step 4.

NO - Intermittent failure, the system is OK at this time.


4. Update the ECM/PCM if it does not have the latest software, ECM/PCM Update (A/T) or substitute a known-good ECM/PCM. Initial Inspection and Diagnostic Overview

5. Check for Temporary DTCs or DTCs with the HDS.

Is DTC P0603* (P062F)** indicated?
YES - If the ECM/PCM was updated, substitute a known-good ECM/PCM, Initial Inspection and Diagnostic Overview then recheck. If the ECM/PCM was substituted, go to step 1.

NO - If the ECM/PCM was updated, troubleshooting is complete. If the ECM/PCM was substituted, replace the original ECM/PCM. Service and Repair If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting.