Backup Lamp Switch: Service and Repair

Back-up Light Switch Test and Replacement

1. Disconnect the back-up light switch 2P connector (A).






2. Check for continuity between back-up light switch 2P connector terminals No. 1 and No. 2. There should be continuity only when the shift lever is in reverse.
- If the test result is ok, go to step 8.

- If the test result is faulty, go to step 3.

3. Remove the shift lever knob, the boot holder, the shift boot, the shift lever, and the shift lever spring. Manual Transmission Removal

4. Remove the three way catalytic converter (TWC). Manual Transmission Removal

5. Remove the propeller shaft. Propeller Shaft Removal






6. Place a floor jack under the transmission, and remove the three transmission rear mount bolts (A), and then lower the transmission 65 mm (2.56 in.) (B).






7. Replace the back-up light switch (A) and the sealing washer (B) using the commercially available 3/8'' crow foot wrench (19 mm) (C).

8. Connect the back-up light switch 2P connector.