Programming and Relearning

Passenger's Weight Sensor Unit Calibration

('06-09 models)

When you replace the passenger's weight sensors or passenger's weight sensor unit, calibrate the passenger's weight sensor unit.

While calibrating the passenger's weight sensor unit, observe these precautions:

- Make sure all components of the passenger's seat are correctly installed.

- Make sure nothing is on or under the passenger's seat.

- Make sure there is nothing in the passenger's seat-back pocket.

- Keep the windows closed.

- Do all calibration procedures except test-driving, in the service bay.

- Make sure the vehicle is on level ground.

- Keep the A/C and the heater off.

- Do not touch the passenger's seat until you are prompted to or when you have completed the calibration.

- Do not expose the passenger's seat to sudden temperature changes.

1. Position the passenger's seat to the rearmost position and adjust the recliner to the forwardmost position. Do not move the seat from this position.

2. Turn the ignition switch to LOCK (0).

3. Connect the HDS to the data link connector (DLC) (A).

4. Turn the ignition switch to ON (II).

5. Make sure the HDS communicates with the vehicle and the SRS unit. If it does not, troubleshooting the DLC circuit. Testing and Inspection

6. Drive the vehicle, and accelerate to 20 mph (36 km/h), then stop on level ground.

7. From the Main Menu, select SRS, then Calibration, then Misc Test, then select SWS INIT, and follow the prompts until the calibration is complete.