Manufacturer Code Charts: 2703

DTC Troubleshooting: 1501, 2703

DTC 1501:

Aircon Error

DTC 2703:

Aircon Diag

NOTE:

- Check the vehicle battery condition first Testing and Inspection.
- Check for B-CAN DTCs and resolve them before troubleshooting.
- Before you troubleshoot, make sure to follow the General Troubleshooting Information How to Troubleshoot the Navigation System.
- DTC 1501 and/or 2703 can be stored when the ignition switch is at ACCESSORY (I). With the ignition switch is in ACCESSORY (I), the climate control unit is turned off and the navigation unit loses communication and stores DTCs. Therefore, there is a possibility that the system is normal even DTC 1501 and/or 2703 is stored. Check System Links Navigation System Diagnostic Mode with the engine running, and if it shows normal, the system is OK at this time. If not, do this troubleshooting.

1. Clear the hard error code How to Troubleshoot the Navigation System.

2. Turn the ignition switch to LOCK (0) and then back to ON (II).

3. Go into the Diagnostic Menu, and select the Self-Diagnosis Mode in the Select Diagnosis Items menu Navigation System Diagnostic Mode.

4. Check the System Links.

Is the A/C icon red?

YES -

Go to step 5.

NO -

Intermittent failure, the system is OK at this time.�

5. Turn the ignition switch to LOCK (0).

6. Disconnect navigation unit connector B (32P).

7. Connect navigation unit connector B (32P) terminals No. 4, No. 20, and No. 21 with a jumper wire.





8. Turn the ignition switch to ON (II).

9. Do the climate control Self-Diagnostic Mode How to Troubleshoot the Climate Control System.

Are both HEAT/VENT indicators solid with the remaining icons blinking?

YES -

Replace the navigation unit Service and Repair.�

NO -

Go to step 10.

10. Turn the ignition switch to LOCK (0), then disconnect the jumper wire.

11. Disconnect climate control unit connector B (12P).

12. Connect climate control unit connector B (12P) terminals No. 7, No. 8, and No. 9 with a jumper wire.






13. Check for continuity between navigation unit connector B (32P) terminals No. 4, No. 20, and between terminals No. 20 and No. 21.





Is there continuity?

YES -

Go to step 14.

NO -

Repair an open in the wire(s) between the navigation control unit and the climate control unit.�

14. Disconnect the jumper wire.

15. Check for continuity between body ground and navigation unit connector B (32P) terminals No. 4, No. 20, and No. 21 individually.





Is there continuity?

YES -

Repair a short to body ground in the wire(s) between the navigation control unit and the climate control unit.�

NO -

Go to step 16.

16. Check for continuity between the terminal of navigation unit connector B (32P) according to the table.









Is there continuity?

YES -

Repair a short in the wire(s) between the navigation unit and climate control unit.�

NO -

Go to step 17.

17. Turn the ignition switch to ON (II).

18. Measure the voltage between body ground and navigation unit connector B (32P) terminals No. 4, No. 20, and No. 21 individually.





Is there more than 0.2 V?

YES -

Repair a short to power in the wire(s) between the navigation unit and the climate control unit.�

NO -

Replace the climate control unit Climate Control Unit Removal/Installation (With Navigation).�