Door Key Cylinder Switch Test

Door Key Cylinder Switch Test

1. Remove the driver's door panel Front Door Panel Removal/Installation (4-Door).

2. Disconnect the 10P connector (A) from the door lock actuator (key cylinder switch) (B).





3. Check for continuity between the terminals.

- There should be continuity between terminals No. 9 and No. 5 when the door key cylinder switch is in LOCK position. (With security)
- There should be no continuity between terminals No. 9 and No. 5 when the door key cylinder switch is in the neutral or UNLOCK position. (With security)
- There should be continuity between terminals No. 8 and No. 5 when the door key cylinder switch is in UNLOCK position.
- There should be no continuity between terminals No. 8 and No. 5 when the door key cylinder switch is in the neutral or LOCK position.

4. If the continuity is not as specified, replace the door latch/actuator assembly Service and Repair.