Front Passenger's Power Window Motor Test

Front Passenger's Power Window Motor Test

With AUTO UP/AUTO DOWN function

Motor Test

1. Remove the front passenger's power window switch:

- 4-door Front Passenger's Power Window Switch Replacement (4-Door)
- 2-door Front Passenger's Power Window Switch Replacement (2-Door)

2. Test the motor in each direction by connecting battery power and ground to the front passenger's power window switch 37P connector (A) according to the table.






4-door





2-door





3. If the motor does not run or fails to run smoothly, go to step 4, if the motor runs smoothly, go to step 8.

4. For 4-door: remove the door panel Front Door Panel Removal/Installation (4-Door).

5. Disconnect the 6P connector (A) from the front passenger's power window motor (B).






6. Check for continuity between the front passenger's power window switch 37P connector terminals and front passenger's power window motor 6P connector terminals as shown. There should be continuity.









7. If there is no continuity, repair an open or high resistance in the wire(s). If the wire harness is OK, replace the front passenger's power window motor.

Hall IC unit (Pulser) Test

8. Do the front passenger's power window switch input test at terminals No. 26, No. 27, and No. 28 Front Passenger's Power Window Switch Input Test.

Without AUTO UP/AUTO DOWN function

1. Remove the front passenger's power window switch.

- 4-door Front Passenger's Power Window Switch Replacement (4-Door)
- 2-door Front Passenger's Power Window Switch Replacement (2-Door)

2. Test the motor in each direction by connecting battery power and ground to the front passenger's power window switch 37P connector (A) according to the table.






4-door





2-door





3. If the motor does not run or fails to run smoothly, go to step 4.

4. For 4-door: remove the door panel Front Door Panel Removal/Installation (4-Door).

5. Disconnect the 2P connector (A) from the front passenger's power window motor (B).






6. Check for continuity between the front passenger's power window switch 37P connector terminals and front passenger's power window motor 2P connector terminals as shown. There should be continuity.









7. If the wire harness is OK, replace the front passenger's power window motor.