SRS Unit Replacement

SRS Unit Replacement

Removal

1. Do the battery terminal disconnection procedure Procedures, then wait at least 3 minutes before starting work.

2. Remove the driver's and passenger's dashboard center lower cover Dashboard Center Lower Cover Removal/Installation.

3. Remove the TORX bolt (A) using a TORX T30 bit.






4. Remove the audio disc changer (with navigation system) Service and Repair or center pocket (without navigation system) Dashboard Center Pocket Removal/Installation (Without Navigation).

5. Disconnect SRS unit connectors A (39P) and B (39P) from the SRS unit (C).

NOTE: The SRS unit connectors have lever locks. Release the locks before disconnecting the connectors Service and Repair.





6. Remove the TORX bolts (D) using a TORX T30 bit, then pull out the SRS unit.

Installation

1. Install the SRS unit (A) with a new TORX bolt (B),using a TORX T30 bit.

NOTE: Be sure the SRS unit is sitting squarely against it's bracket before torquing the TORX bolt.






2. Install the new TORX bolts (A) using a TORX T30 bit, then connect the connectors (B) to the SRS unit (C); push them into position until they click Service and Repair.





3. Do the battery terminal reconnection procedure Procedures.

4. Make sure the SRS unit has the latest software. If it does not have the latest, update the software in the SRS unit SRS Unit Update.

5. Do the ODS unit initialization Programming and Relearning.

6. Check the operation of the ODS unit with the HDS ODS Unit Operation Check.

7. Confirm proper SRS operation: Turn the ignition switch to ON (II); the SRS indicator should come on for about 6 seconds and then go off.

8. Reinstall all removed parts.