Safing Sensor: Service and Repair

Rear Safing Sensor Replacement

Removal

1. Do the battery terminal disconnection procedure Procedures, then wait at least 3 minutes before starting work.

2. Remove the rear seat cushion Rear Seat Cushion Cover Replacement.

3. Disconnect the SRS floor wire harness 2P (4-door) or 4P (2-door) connector (A) from the rear safing sensor (B).





4. Remove the TORX bolt (C) using a TORX T30 bit, then remove the rear safing sensor.

Installation

1. Install the rear safing sensor (A) with a new TORX bolt (B), using a TORX T30 bit. Connect the SRS floor wire harness 2P (4-door) or 4P (2-door) connector (C) to the rear safing sensor.





2. Do the battery terminal reconnection procedure Procedures.

3. Clear any DTCs with the HDS Reading and Clearing Diagnostic Trouble Codes.

4. Confirm proper SRS operation: Turn the ignition switch to ON (II); the SRS indicator should come on for about 6 seconds and then go off.

5. Reinstall all removed parts.