M/T Mainshaft Bearing and Oil Seal Replacement

M/T Mainshaft Bearing and Oil Seal Replacement

Special Tools Required

- Oil seal driver, 65 mm 07JAD-PL90100
- Adjustable bearing puller, 25-40 mm 07736-A01000B
- Bearing driver attachment, 42 x 47 mm 07746-0010300
- Driver handle, 15 x 135L 07749-0010000Slide hammer, 3/8"-16 UNF commercially available
1. Remove the ball bearing (A) from the clutch housing (B) using the 25-40 mm adjustable bearing puller (C) and a commercially available 3/8"-16 UNF slide hammer (D).






2. Remove the oil seal (A) from the clutch housing.
NOTE: Be careful not to damage the clutch housing while removing the oil seal.






3. Drive in a new oil seal from the transmission side using the 15 x 135L driver handle (A) and the 42 x 47 mm bearing driver attachment (B).






4. Drive in a new ball bearing from the transmission side using the 65 mm oil seal driver (A).