Passenger's Airbag Cutoff Indicator Illumination Bulb Test/Replacement

Passenger's Airbag Cutoff Indicator Illumination Bulb Test/Replacement

1. Remove the audio unit Audio Unit Removal/Installation (Without Navigation) or navigation unit from the dashboard Audio-Navigation Unit Removal/Installation.

2. Turn the ignition switch to ON (II).

3. Measure the voltage between passenger's airbag cutoff indicator 4P connector terminal No. 3 and body ground. There should be battery voltage.

- If there is battery voltage, go to step 4.
- If there is no battery voltage, check the No. 29 (10 A) fuse in the under-dash fuse/relay box. If the fuse is blown, replace it and retest. If the fuse blows again, check for a short in the No. 29 (10 A) fuse line.





4. Reconnect the 4P connector to the passenger's airbag cutoff indicator.

5. Install a jumper wire between passenger's airbag cutoff indicator connector (4P) terminal No. 2 and body ground. The indicator should come on.

- If the indicator comes on, check the dashlight brightness controller circuit.
- If the indicator does not come on, go to step 6 to replace the passenger's airbag cutoff indicator.





6. Turn the ignition switch to LOCK (0), and disconnect the passenger's airbag cutoff indicator 4P connector.

7. Remove the mounting screws (A) and push out the passenger's airbag cutoff indicator (B) from behind the center panel.





8. Reinstall the parts in the reverse order of removal.