Seat Position Sensor: Service and Repair

Driver's Seat Position Sensor Replacement

Removal

NOTE: Do not turn the ignition switch to ON (II), and do not connect the battery cable while removing the driver's seat position sensor.

1. Do the battery terminal disconnection procedure Procedures, then wait at least 3 minutes before starting work.

2. Remove the recline cover Front Seat Recline Cover Removal/Installation.

3. Disconnect the seat position sensor harness 2P connector (A) from the driver's seat position sensor (B).






4. Remove the TORX bolt (C) using a TORX T30 bit, then remove the driver's seat position sensor (B) through the space between the seat track and slide as shown.






Installation (Manual seat)

NOTE:

- Be sure to install the harness so it does not pinched or interfere with other parts.
- Do not turn the ignition switch to ON (II), and do not connect the battery cable while installing the driver's seat position sensor.

1. Install the driver's seat position sensor (A) with a new TORX bolt (B).





2. Connect the seat position sensor harness 2P connector (C) to the driver's seat position sensor.

3. Install the recline cover Front Seat Recline Cover Removal/Installation.

4. Do the battery terminal reconnection procedure Procedures.

5. Check the operation of the driver's seat position sensor with the HDS Driver's Seat Position Sensor Operation Check.