M/T Differential Thrust Clearance Adjustment

M/T Differential Thrust Clearance Adjustment

Special Tools Required

- Driver Handle, 40 mm I.D. 07746-0030100

1. Remove the left driveshaft side oil seal M/T Differential Oil Seal Replacement.

2. Install the 80 mm shim (A) that's the same size as the one you removed.






3. Install the differential assembly (A) into the clutch housing.






4. Install the transmission housing onto the clutch housing, then tighten the 8 mm flange bolts in a crisscross pattern in several steps.






5. Use the 40 mm inner driver handle to bottom the differential assembly in the clutch housing.






6. Measure the clearance between the 80 mm shim and the bearing outer race in transmission housing.










7. If the clearance exceeds the standard, select a new 80 mm shim from the following table. If the clearance measured in step 6 is within the standard, go to step 10.

80 mm Shim:





8. Remove the bolts and the transmission housing.

9. Replace the thrust shim selected in step 7, then recheck the clearance.

10. Install a new left driveshaft side oil seal M/T Differential Oil Seal Replacement.

11. Reinstall the transmission housing.