Washer Motor Test

Washer Motor Test

1. Remove the front bumper Front Bumper Removal/Installation.

2. Disconnect the 2P connector (A) from the washer motor (B).

NOTE: The illustration shows USA models.





3. Test the motor by connecting battery power to terminal No. 2 and ground terminal No. 1 of the washer motor. The motor should run.

- If the motor does not run or fails to run smoothly, replace it.
- If the motor runs smoothly, but little or no washer fluid is pumped, check for a disconnected or blocked washer hose, or a clogged washer motor outlet.