Memory Positioning Switch: Service and Repair

Driving Position Memory Switch Test/Replacement

1. Remove the driver's door panel.

- 4-door Front Door Panel Removal/Installation (4-Door)
- 2-door Front Door Panel Removal/Installation (2-Door)

2. Disconnect the 7P connector (A) from the driver's position memory switch (B).





3. Remove the four screws, then remove the switch from the door panel.

4. Check for continuity between the terminals in each switch position according to the table.

NOTE:

- Make sure the correct test lead (+ or -) is placed on the terminal.
- When checking for continuity across the diode, use the diode setting () on the digital volt/ohm meter to check the diode bias.
- Be careful of this characteristic; diode bias causes a diode to fully conduct electricity in one direction (forward), while not at all in the opposite direction (reverse).





5. If the continuity is not as specified, replace the switch.