Front Individual Map Light Test/Replacement (Without Moonroof)

Front Individual Map Light Test/Replacement

Without moonroof

1. Turn the map light switch OFF.

2. Carefully pry the lens (A) off with a flat-tip screwdriver.









3. Remove the screws, then remove the front individual map lights (B).

4. Disconnect the connector (C) from the map lights.

5. Check for continuity between the terminals.

- There should be continuity between terminals No. 1 and No. 2 with the switch in the ON position.
- There should be no continuity between terminals No. 1 and No. 2 with the switch in the OFF position.

6. If the continuity is not as specified, check the bulb. If the bulb is OK, replace the map light.

7. Install the light in the reverse order of removal.