Seat Position Sensor: Service and Repair

Driver's Seat Position Sensor Replacement

Removal (Power seat)

NOTE: Do not turn the ignition switch to ON (II) while removing the driver's seat position sensor.

1. Raise the driver's seat all the way up.

2. Remove the driver's seat Front Seat Removal/Installation.

3. Disconnect the driver's seat wire harness 2P connector (A) from the driver's seat position sensor (B).





4. Remove the nut (C), then remove the driver's seat position sensor.

Installation (Power seat)

NOTE:

- Be sure to install the harness so it does not pinched or interfere with other parts.
- Do not turn the ignition switch to ON (II) while installing the driver's seat position sensor.
- After installing the driver's seat position sensor, make sure it is clean. Keep it away from dust.

1. Install the driver's seat position sensor (A) with the nut (B), then connect the driver's seat wire harness 2P connector (C) to the driver's seat position sensor.





2. Reinstall the driver's seat Front Seat Removal/Installation.

3. Clear any DTCs with the HDS.

4. Check the operation of the driver's seat position sensor with the HDS Driver's Seat Position Sensor Operation Check.

5. Confirm proper SRS operation: Turn the ignition switch to ON (II); the SRS indicator should come on for about 6 seconds and then go off.

Removal (Manual seat)

NOTE: Do not turn the ignition switch to ON (II) while removing the driver's seat position sensor.

1. Raise the driver's seat all the way up.

2. Remove the driver's seat Front Seat Removal/Installation.

3. Remove the recline cover.

- 2-door Front Seat Cushion Cover Replacement (2-Door)

- 4-door Front Seat Cushion Cover Replacement (4-Door)

4. Disconnect the driver's seat position sensor harness 2P connector (A) from the driver's seat position sensor (B).





5. Remove the TORX bolt (C) using a TORX T30 bit, then remove the driver's seat position sensor.

Installation (Manual seat)

NOTE:

- Be sure to install the harness so it does not pinched or interfere with other parts.
- Do not turn the ignition switch to ON (II) while installing the driver's seat position sensor.
- After installing the driver's seat position sensor, make sure it is clean. Keep it away from dust.

1. Install the driver's seat position sensor (A) with the new TORX bolt (B), using a TORX T30 bit. Connect the driver's seat position sensor harness 2P connector (C) to the driver's seat position sensor.





2. Install the recline cover.

- 2-door Front Seat Cushion Cover Replacement (2-Door)

- 4-door Front Seat Cushion Cover Replacement (4-Door)

3. Install the driver's seat Front Seat Removal/Installation.

4. Clear any DTCs with the HDS.

5. Check the operation of the driver's seat position sensor with the HDS Driver's Seat Position Sensor Operation Check.

6. Confirm proper SRS operation: Turn the ignition switch to ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.