DTC Troubleshooting

DTC Troubleshooting: P0711 (28)

DTC P0711:

Problem in ATF Temperature Sensor Circuit

NOTE:

- Before you troubleshoot, record all freeze data and any on-board snapshot with the HDS, and review General Troubleshooting Information How To Troubleshoot The A/T System.
- This code is caused by an electrical circuit problem and cannot be caused by a mechanical problem in the transmission.

1. Turn the ignition switch to ON (II).

2. Check the ATF Temperature with the HDS in the A/T Data List.

Does the ATF Temperature indicate -4 °F (-20 °C ) or higher?

YES -

Intermittent failure, the system is OK at this time.�

NO -

Go to step 3.

3. Start the engine, and wait for at least 10 minutes. Test the stall speed RPM A/T Stall Speed Test three times.

4. Check the ATF Temperature with the HDS in the A/T Data List.

Does the ATF Temperature indicate -4 °F (-20 °C ) or below?

YES -

Replace the ATF temperature sensor Service and Repair.�

NO -

Intermittent failure, the system is OK at this time.�