U0151

DTC Troubleshooting: U0151

DTC U0151:

Gauge Control Module Lost Communication With SRS Unit

NOTE:

- SRS components are located in this area. Review the SRS component locations Locations and precautions and procedures Service and Repair before doing repairs or servicing.
- If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A Troubleshooting - B-CAN System Diagnosis Test Mode A.

1. Clear the DTCs with the HDS.

2. Turn the ignition switch to LOCK (0) and then back to ON (II).

3. Wait for at least 6 seconds.

4. Check for DTCs with the HDS.

Is DTC U0151 indicated?

YES -

Go to step 5.

NO -

Intermittent failure, the system is OK at this time. Check for loose or poor connections.�

5. Check for SRS DTCs with the HDS Reading and Clearing Diagnostic Trouble Codes.

Are any DTCs indicated?

YES -

Go to the indicated DTC's troubleshooting, then recheck.�

NO -

Go to step 6.

6. Turn the ignition switch to LOCK (0).

7. Disconnect the gauge control module 32P connector.

8. Disconnect SRS unit connector A (39P).

9. Check for continuity between gauge control module 32P connector terminal No. 19 and No. 20 and SRS unit connector A (39P) terminal No. 6 and No. 7 respectively.









Is there continuity?

YES -

Go to step 10.

NO -

Repair an open or high resistance in the wire.�

10. Reconnect the gauge control module 32P connector and SRS unit connector A (39P).

11. Clear the DTCs with the HDS.

12. Turn the ignition switch to LOCK (0) and then back to ON (II).

13. Wait for at least 6 seconds.

14. Check for DTCs with the HDS.

Is DTC U0151 indicated?

YES -

Replace the gauge control module Service and Repair.�

NO -

Replace the SRS unit SRS Unit Replacement.�